AT89C51IC2-SLSCM datasheet(13/146 Pages) ATMEL

13 / 146 page

AT89C51IC2

4301A–8051–01/04

SDA is the bidirectional 2-wire data line

RST

I/O

Reset: A high on this pin for two machine cycles while the oscillator is running, resets

the device. An internal diffused resistor to V

SS permits a power-on reset using only an

external capacitor to V

CC. This pin is an output when the hardware watchdog forces a

system reset.

ALE/PROG

O (I)

Address Latch Enable/Program Pulse: Output pulse for latching the low byte of the

address during an access to external memory. In normal operation, ALE is emitted at a

constant rate of 1/6 (1/3 in X2 mode) the oscillator frequency, and can be used for

external timing or clocking. Note that one ALE pulse is skipped during each access to

external data memory. This pin is also the program pulse input (PROG) during Flash

programming. ALE can be disabled by setting SFR’s AUXR.0 bit. With this bit set, ALE

will be inactive during internal fetches.

PSEN

Program Strobe ENable: The read strobe to external program memory. When execut-

ing code from the external program memory, PSEN is activated twice each machine

cycle, except that two PSEN activations are skipped during each access to external

data memory. PSEN is not activated during fetches from internal program memory.

External Access Enable: EA must be externally held low to enable the device to fetch

code from external program memory locations 0000H to FFFFH (RD). If security level 1

is programmed, EA will be internally latched on Reset.

Table 13. Pin Description for 40/44 Pin Packages (Continued)

Mnemonic

Pin Number

Type

Name and Function

PLCC44

VQFP44 1.4

AT89C51IC2-SLSCM Datasheet(PDF) 13 Page - ATMEL Corporation