AT90PWM2 datasheet(301/365 Pages) ATMEL

301 / 365 page

301

AT90PWM2/3

4317B–AVR–02/05

Reading the Fuse and Lock

Bits

The algorithm for reading the Fuse and Lock bits is as follows (refer to “Programming

the Flash” on page 296 for details on Command loading):

A: Load Command “0000 0100”.

Set OE to “0”, BS2 to “0” and BS1 to “0”. The status of the Fuse Low bits can

now be read at DATA (“0” means programmed).

Set OE to “0”, BS2 to “1” and BS1 to “1”. The status of the Fuse High bits can

now be read at DATA (“0” means programmed).

Set OE to “0”, BS2 to “1”, and BS1 to “0”. The status of the Extended Fuse bits

can now be read at DATA (“0” means programmed).

Set OE to “0”, BS2 to “0” and BS1 to “1”. The status of the Lock bits can now be

read at DATA (“0” means programmed).

Set OE to “1”.

Figure 141. Mapping Between BS1, BS2 and the Fuse and Lock Bits During Read

Reading the Signature Bytes

The algorithm for reading the Signature bytes is as follows (refer to “Programming the

Flash” on page 296 for details on Command and Address loading):

A: Load Command “0000 1000”.

B: Load Address Low Byte (0x00 - 0x02).

Set OE to “0”, and BS1 to “0”. The selected Signature byte can now be read at

DATA.

Set OE to “1”.

Reading the Calibration Byte

The algorithm for reading the Calibration byte is as follows (refer to “Programming the

Flash” on page 296 for details on Command and Address loading):

A: Load Command “0000 1000”.

B: Load Address Low Byte, 0x00.

Set OE to “0”, and BS1 to “1”. The Calibration byte can now be read at DATA.

Set OE to “1”.

Lock Bits

BS2

Fuse High Byte

BS1

DATA

Fuse Low Byte

BS2

Extended Fuse Byte

AT90PWM2 Datasheet(PDF) 301 Page - ATMEL Corporation