M58PR512LE datasheet(32/123 Pages) NUMONYX

32 / 123 page

Command interface

M58PR512LE, M58PR001LE

32/123

4.11

Program/Erase Resume command

The Program/Erase Resume command restarts the program or erase operation suspended

by the Program/Erase Suspend command. One bus write cycle is required to issue the

command. The command can be issued to any address.

The Program/Erase Resume command does not change the read mode of the banks. If the

suspended bank was in read status register, read electronic signature or read CFI query

mode, the bank remains in that mode and outputs the corresponding data.

If a program command is issued during a block erase suspend, then the erase cannot be

resumed until the program operation is complete.

See Appendix C, Figure 26: Program suspend and resume flowchart and pseudocode and

Figure 28: Erase suspend and resume flowchart and pseudocode for flowcharts for using

the Program/Erase Resume command.

4.12

Protection Register Program command

The Protection Register Program command programs the user OTP area of the Protection

The device features 16 OTP areas of 128 bits and one OTP area of 64 bits, as shown in

Figure 6: Protection Register memory map.

The areas are programmed one word at a time. When shipped, all bits in the area are set to

‘1’. Only the user can program the bits to ‘0’.

Two bus write cycles are required to issue the Protection Register Program command.

●

The first bus cycle sets up the Protection Register Program command.

●

The second latches the address and data to be programmed to the Protection Register

and starts the Program/Erase Controller.

Read operations to the bank being programmed output the status register content after the

program operation has started. Attempting to program a previously-protected Protection

The Protection Register Program cannot be suspended. Dual operations between the EFA

and the Protection Register memory space are not allowed (see Table 20: Dual operation

limitations for details).

The two Protection Register locks are used to protect the OTP areas from further

modification. The protection of the OTP areas is not reversible. Refer to Figure 6: Protection

See Appendix C, Figure 31: Protection Register program flowchart and pseudocode for a

flowchart for using the Protection Register Program command.

M58PR512LE Datasheet(PDF) 32 Page - Numonyx B.V