MAX14821 datasheet(15/29 Pages) MAXIM

15 / 29 page

�� Maxim Integrated Products 15

MAX14821

IO-Link Device Transceiver

Pin/Bump Descriptions (continued)

NAME

FUNCTION

TQFN-EP

WLP

TXQ

Transmit Level Input. The logic on the C/Q output is the inverse logic level of the signals on

the TXC and TXQ inputs. TXQ is ANDed with TXC. Drive TXQ high if not in use.

TXC

Transmit Communication Input. The logic on the C/Q output is the inverse logic level of the

signals on the TXC and TXQ inputs. TXC is ANDed with TXQ. Drive TXC high if not in use.

TXEN

Transmitter Enable. Drive TXEN high to enable the C/Q transmitter. TXEN is referenced to VL.

Receiver Output. RX is the inverse logic level of C/Q. RX is always high when the RxDis bit in

the CQConfig register is set to 1.

Active-Low Wake-Up Output. WU is a push-pull output referenced to VL. WU pulses low for

190Fs (typ) when a valid wake-up pulse is detected on the C/Q line.

Logic Input of the DO Output. LO is the logic input that drives DO. LO is referenced to VL.

Logic Output of the 24V DI Logic Input. LI is the inverse logic of DI. LI is referenced to VL.

Open-Drain Undervoltage Indicator Output. In case of an undervoltage, the UV open-drain

transistor is off.

24V Logic-Level Digital Input

C1, C2

GND

Ground

C/Q

SIO/IO-Link Data Input/Output. Drive TXEN high to enable the C/Q driver. The logic on the

C/Q output is the inverse logic level of the signals on the TXC and TXQ inputs. RX is the logic

inverse of C/Q. The C/Q driver output level can be set by the TXC/TXQ inputs or programmed

by the Q bit. The level on C/Q can be read by the RX ouput or the QLvl bit.

24V Logic-Level Digital Output. DO is the inverse logic level of the LO input and can be digi-

tally controlled through the DIOConfig register.

VCC

Power-Supply Input. Bypass VCC to GND with a 1FF ceramic capacitor.

Protected 24V Supply Output. VP is one diode drop below VCC. VP is reverse-polarity protect-

ed and can be used as a 24V protected supply to the sensor or actuator electronics.

—

Exposed Pad (TQFN Only). Connect EP to GND.

MAX14821 Datasheet(PDF) 15 Page - Maxim Integrated Products