10-Bit, Multichannel ADCs/DACs with FIFO,

Temperature Sensing, and GPIO Ports

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are

implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.

47 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600

© 2004 Maxim Integrated Products

Printed USA

is a registered trademark of Maxim Integrated Products.

Package Information (continued)

(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,

8.   COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.

6.   ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.

5.  DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm 

     FROM TERMINAL TIP.  

4.  THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1 

     SPP-012.  DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE 

     ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.

9.   DRAWING CONFORMS TO JEDEC MO220, EXCEPT FOR 0.4mm LEAD PITCH PACKAGE T4866-1.

7.   DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.

3.  N IS THE TOTAL NUMBER OF TERMINALS.

2.  ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.

1.  DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.

NOTES:

10.   WARPAGE SHALL NOT EXCEED 0.10 mm.

E

2

2

21-0141

PACKAGE OUTLINE

36, 40, 48L THIN QFN, 6x6x0.8mm