DA14531MOD

Final

Datasheet

Revision 3.1

31-May-2021

CFR0011-120-00

28 of 32

© 2021-2021 Dialog Semiconductor

The MSIP ID can be applied directly on end-product's label. The ID should be clearly visible on the

final end-product. The integrator of the module should refer to the labeling requirements for Korea

available on the Korea Communications Commission (KCC) website.

11.7 Australia/ New Zealand (RCM)

the

module’s CE test reports can be used in part to demonstrate compliance in accordance with

Short Range Devices- SRD Standards. The integrator of the module must construct a compliance

folder with all relevant test reports: RF, EMC, Electrical Safety and DoC (Declaration of Conformity).

11.8 South Africa (ICASA)

South Africa certification is based on RED(CE) approval.

TA-2020/5882

APPROVED

Approval is granted to print labels for the products as described below:

1.

For use as Label on the product size: 80 mm (W) X 40 mm (H). To be printed on the product.

2.

For use as Label on the package size: 80 mm (W) X 40 mm (H). To be printed on the

package

End-product may need to follow additional requirement according to regulation EMC.

11.9 Brazil (Anatel)

05382-20-12967

The module has been tested and found to be compliant according to following Category II standards:

“Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar

interferência em sistemas devidamente autorizados.

”