ADF4158 datasheet(16/36 Pages) AD

16 / 36 page

ADF4158

Rev. 0 | Page 16 of 36

R-DIVIDER REGISTER (R2) MAP

With Register R2 DB[2:0] set to [0, 1, 0], the on-chip R-divider

Reserved Bits

All reserved bits should be set to 0 for normal operation.

CSR Enable

Setting this bit to 1 enables cycle slip reduction. This is a

method for improving lock times. Note that the signal at the PFD

must have a 50% duty cycle in order for cycle slip reduction to

work. In addition, the charge pump current setting must be set

to a minimum. See the Cycle Slip Reduction for Faster Lock

Times section for more information.

Also note that the cycle slip reduction feature can only be

operated when the phase detector polarity setting is positive

(DB6 in Register R3). It cannot be used if the phase detector

polarity is set to negative.

Charge Pump Current Setting

DB[27:24] set the charge pump current setting (see Figure 24).

Set these bits to the charge pump current that the loop filter is

designed with.

Prescaler (P/P + 1)

The dual-modulus prescaler (P/P + 1), along with the INT,

FRAC, and MOD counters, determines the overall division

ratio from the RFIN to the PFD input.

Operating at CML levels, it takes the clock from the RF input

stage and divides it down for the counters. It is based on

a synchronous 4/5 core. When set to 4/5, the maximum RF

frequency allowed is 3 GHz. Therefore, when operating

the ADF4158 above 3 GHz, the prescaler must be set to 8/9.

The prescaler limits the INT value.

With P = 4/5, NMIN = 23.

With P = 8/9, NMIN = 75.

RDIV2

Setting DB21 to 1 inserts a divide-by-2 toggle flip-flop between

the R-counter and the PFD. This can be used to provide a 50%

duty cycle signal at the PFD for use with cycle slip reduction.

Reference Doubler

Setting DB20 to 0 feeds the REFIN signal directly to the 5-bit RF

R-counter, disabling the doubler. Setting this bit to 1 multiplies

the REFIN frequency by a factor of 2 before feeding the signal

into the 5-bit R-counter. When the doubler is disabled, the

REFIN falling edge is the active edge at the PFD input to the

fractional synthesizer. When the doubler is enabled, both the

rising edge and falling edge of REFIN become active edges at the

PFD input.

The maximum allowed REFIN frequency when the doubler is

enabled is 30 MHz.

5-Bit R-Counter

The 5-bit R-counter allows the input reference frequency

(REFIN) to be divided down to produce the reference clock

to the phase frequency detector (PFD). Division ratios from

1 to 32 are allowed.

12-Bit MOD Divider

Bits DB[14:3] are used to program the MOD divider, which

determines the duration of the time step in ramp mode.

ADF4158 Datasheet(PDF) 16 Page - Analog Devices

ADF4158 Datasheet(HTML) 16 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Datasheet Download

Link URL