| Electronic Components Datasheet Search |
|
WM8993 Datasheet(PDF) 42 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8993 Datasheet(HTML) 42 Page - Wolfson Microelectronics plc |
|
42 / 229 page ![]() WM8993 Production Data w PD, November 2010, Rev 4.0 42 IN1L_VOL[4:0], IN2L_VOL[4:0], IN1R_VOL[4:0], IN2R_VOL[4:0] VOLUME (dB) 11101 +27.0 11110 +28.5 11111 +30.0 Table 5 Input PGA Volume Range INPUT MIXER ENABLE The WM8993 has two analogue input mixers which allow the Input PGAs and Line Inputs to be combined in a number of ways and output to the ADCs, Output Mixers, or directly to the output drivers via bypass paths. The input mixers MIXINL and MIXINR are enabled by the MIXINL_ENA and MIXINR_ENA register bits, as described in Table 6. These control bits also enable the RXVOICE input path, described in the following section. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION R2 (02h) Power Management (2) 9 MIXINL_ENA 0b Left Input Mixer Enable (Enables MIXINL and RXVOICE input to MIXINL) 0 = Disabled 1 = Enabled 8 MIXINR_ENA 0b Right Input Mixer Enable (Enables MIXINR and RXVOICE input to MIXINR) 0 = Disabled 1 = Enabled Table 6 Input Mixer Enable INPUT MIXER CONFIGURATION AND VOLUME CONTROL The left and right channel input mixers MIXINL and MIXINR can be configured to take input from up to five sources: 1. IN1L or IN1R Input PGA 2. IN2L or IN2R Input PGA 3. IN1LP or IN1RP pin (PGA bypass) 4. RXVOICE mono differential input from IN2LP/VRXN and IN2RP/VRXP 5. MIXOUTL or MIXOUTR Output Mixer (Record path) The Input Mixer configuration and volume controls are described in Table 7 for the Left input mixer (MIXINL) and Table 8 for the Right input mixer (MIXINR). The signal levels from the Input PGAs may be set to Mute, 0dB or 30dB boost. Gain controls for the PGA bypass, RXVOICE and Record paths provide adjustment from -12dB to +6dB in 3dB steps. To prevent pop noise, it is recommended that gain and mute controls for the input mixers are not modified while the signal paths are active. If volume control is required on these signal paths, it is recommended that this is implemented using the input PGA volume controls or the ADC volume controls. The ADC volume controls are described in the “Analogue to Digital Converter (ADC)” section. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |