MP2661 datasheet(21/35 Pages) MPS

Part #	MP2661

Description	4.65V System, 500mA,I2C-Controlled Battery Charger with Power Path Management for Single-Cell Li-Ion Battery

PDF	35 Pages

Scroll/Zoom	100%

Manufacturer	MPS [Monolithic Power Systems]

Direct Link	http://www.monolithicpower.com

Logo

21 / 35 page

MP2661 – 0.5A, 1-CELL CHARGER W/ I2C CONTROL AND POWER PATH

MP2661 Rev. 1.03

www.MonolithicPower.com

4/9/2018

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

Int_gate

_delay

INT

Int_ext

Vin

Power

600ns

Vth

Int_dly

Figure 6: INT signal during Vin powers on

If FET_DIS is set to 1 during the shipping mode,

the IC could still wake up after INT keeping low

for 4s. But in this case, the FET_DIS bit can not

be reset to 0 automatically, it has to be reset to

0 manually through I2C.

2). Reset Mode

The IC can use INT to cut off the path from the

battery to the system when system reset is

needed.

Once the logic at INT is set to low for more than

16s, the battery is disconnected from the

system by turning off the battery MOSFET.

The off state lasts for 4s, then the battery

MOSFET is turned on automatically, and the

system is powered by the battery again. During

the 4s off period, INT pin voltage level could be

high or low. The IC can reset the system by

controlling INT (see Figure 7).

Figure 7: System Reset Function Operation

Profile

MP2661 Datasheet(PDF) 21 Page - Monolithic Power Systems