LAN9211 datasheet(126/147 Pages) SMSC

126 / 147 page

High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support

Datasheet

Revision 2.9 (03-01-12)

126

SMSC LAN9211

DATASHEET

Chapter 6 Timing Diagrams

6.1

Host Interface Timing

The LAN9211 supports the following host cycles:

Read Cycles:

PIO Reads (nCS or nRD controlled)

PIO Burst Reads (nCS or nRD controlled)

RX Data FIFO Direct PIO Reads (nCS or nRD controlled)

RX Data FIFO Direct PIO Burst Reads (nCS or nRD controlled)

Write Cycles:

PIO writes (nCS and nWR controlled)

TX Data FIFO direct PIO writes (nCS or nWR controlled)

All timing measurements were verified under the following conditions:

Temperature: ........................................................................................................................0oC to +70oC

Device VDD:....................................................................................................................+3.30 V +/- 10%

Load Capacitance: ............................................................................................................................ 25pF

6.1.1

Special Restrictions on Back-to-Back Write/Read Cycles

It is important to note that there are specific restrictions on the timing of back-to-back write-read

operations. These restrictions concern reading the control registers after any write cycle to the

LAN9211 device. In many cases there is a required minimum delay between writing to the LAN9211,

and the subsequent side effect (change in the control register value). For example, when writing to the

TX Data FIFO, it takes up to 135ns for the level indication to change in the TX_FIFO_INF register.

In order to prevent the host from reading stale data after a write operation, minimum wait periods must

be enforced. These periods are specified in Table 6.1, "Read After Write Timing Rules". The host

processor is required to wait the specified period of time after any write to the LAN9211 before reading

the resource specified in the table. These wait periods are for read operations that immediately follow

any write cycle. Note that the required wait period is dependant upon the register being read after the

write.

Performing "dummy" reads of the BYTE_TEST register is a convenient way to guarantee that the

minimum write-to-read timing restriction is met. Table 6.1 also shows the number of dummy reads that

are required before reading the register indicated. The number of BYTE_TEST reads in this table is

based on the minimum timing for Tcycle (45ns). For microprocessors with slower busses the number

of reads may be reduced as long as the total time is equal to, or greater than the time specified in the

table. Note that dummy reads of the BYTE_TEST register are not required as long as the minimum

time period is met.

LAN9211 Datasheet(PDF) 126 Page - SMSC Corporation

LAN9211 Datasheet(HTML) 126 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL