ADP5053 datasheet(12/28 Pages) AD

12 / 28 page

Rev 21 Jan 2014 15:09 | Page 12

but does not have a USB dongle connection.

Figure 10. ADP5051 Board Connection Diagram (USB Dongle is Optional)

When the power source and load are connected to the evaluation board, the board can be powered

for operation. If the load is not enabled, enable the load. Verify that it is drawing the proper current

and that the output voltage maintains voltage regulation. After the power-up, the following output

voltage can be measured:

OUT1 = 1.2 V, supply up to a 4 A output load

OUT2 = 3.3 V, supply up to a 4 A output load

OUT3 = 1.8 V, supply up to a 1.2 A output load

OUT4 = 5.0 V, supply up to a 1.2 A output load

REG = 5.0 V, supply up to a 50 mA output load

ADP5051 GUI SOFTWARE

To run the ADP5051 GUI, click Start > All Programs > Analog Devices ADP505x > ADP505x

DEMO GUI-cg. If the program starts correctly and the board is detected, the ADP5051 GUI appears,

as shown in Figure 11. The program default settings are as follows:

ADP5053 Datasheet(PDF) 12 Page - Analog Devices