AT90PWM2 datasheet(243/365 Pages) ATMEL

243 / 365 page

243

AT90PWM2/3

4317B–AVR–02/05

Analog to Digital Converter - ADC

Features

• 10-bit Resolution

• 0.5 LSB Integral Non-linearity

• ± 2 LSB Absolute Accuracy

• 8- 250 µs Conversion Time

• Up to 120 kSPS at Maximum Resolution

• 11 Multiplexed Single Ended Input Channels

• Two Differential input channels with accurate (5%) programmable gain 5, 10, 20 and 40

• Optional Left Adjustment for ADC Result Readout

• 0 - V

CC ADC Input Voltage Range

• Selectable 2.56 V ADC Reference Voltage

• Free Running or Single Conversion Mode

• ADC Start Conversion by Auto Triggering on Interrupt Sources

• Interrupt on ADC Conversion Complete

• Sleep Mode Noise Canceler

The AT90PWM2/3 features a 10-bit successive approximation ADC. The ADC is con-

nected to an 15-channel Analog Multiplexer which allows eleven single-ended input.

The single-ended voltage inputs refer to 0V (GND).

The device also supports 2 differential voltage input combinations which are equipped

with a programmable gain stage, providing amplification steps of 14dB (5x), 20 dB (10x),

26 dB (20x), or 32dB (40x) on the differential input voltage before the A/D conversion.

On the amplified channels, 8-bit resolution can be expected.

The ADC contains a Sample and Hold circuit which ensures that the input voltage to the

ADC is held at a constant level during conversion. A block diagram of the ADC is shown

in Figure 115.

The ADC has a separate analog supply voltage pin, AV

CC. AVCC must not differ more

than ± 0.3V from V

CC. See the paragraph “ADC Noise Canceler” on page 250 on how to

connect this pin.

Internal reference voltages of nominally 2.56V or AV

CC are provided On-chip. The volt-

age reference may be externally decoupled at the AREF pin by a capacitor for better

noise performance.

AT90PWM2 Datasheet(PDF) 243 Page - ATMEL Corporation