RF69 datasheet(77/81 Pages) ETC2

Part #	RF69

Description	Low Power Integrated UHF Transceiver with On-Chip 20dBm PA

PDF	81 Pages

Scroll/Zoom	100%

Manufacturer	ETC2 [List of Unclassifed Manufacturers]

Direct Link

Logo

77 / 81 page

RF69

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

7.2.2. Manual Reset

A manual reset of the RF69 is possible even for applications in which VDD cannot be physically disconnected. Pin 6

should be pulled high for a hundred microseconds, and then released. The user should then wait for 5 ms before using the

chip.

VDD

Pin 6

High-Z

> 100 us

‟‟

‟

Wait for

5 ms

High-Z

Chip is ready from

this point on

(input)

Figure 40. Manual Reset Timing Diagram

Note

whilst pin 6 is driven high, an over current consumption of up to ten milliamps can be seen on VDD.

7.3. Reference Design

Please contact your representative for evaluation tools, reference designs and design assistance. Note that all

schematics shown in this section are full schematics, listing ALL required components, including decoupling capacitors.

Figure 41. +13dBm Schematic

Page 76

RF69 Datasheet(PDF) 77 Page - List of Unclassifed Manufacturers