AT90PWM2 datasheet(207/365 Pages) ATMEL

207 / 365 page

207

AT90PWM2/3

4317B–AVR–02/05

Figure 103. Start Bit Sampling

When the clock recovery logic detects a high (idle) to low (start) transition on the RxD

line, the start bit detection sequence is initiated. Let sample 1 denote the first zero-sam-

ple as shown in the figure. The clock recovery logic then uses samples 8, 9, and 10 for

Normal mode, and samples 4, 5, and 6 for Double Speed mode (indicated with sample

numbers inside boxes on the figure), to decide if a valid start bit is received. If two or

more of these three samples have logical high levels (the majority wins), the start bit is

rejected as a noise spike and the Receiver starts looking for the next high to low-transi-

tion. If however, a valid start bit is detected, the clock recovery logic is synchronized and

the data recovery can begin. The synchronization process is repeated for each start bit.

Asynchronous Data Recovery

When the receiver clock is synchronized to the start bit, the data recovery can begin.

The data recovery unit uses a state machine that has 16 states for each bit in Normal

mode and eight states for each bit in Double Speed mode. Figure 104 shows the sam-

pling of the data bits and the parity bit. Each of the samples is given a number that is

equal to the state of the recovery unit.

Figure 104. Sampling of Data and Parity Bit

The decision of the logic level of the received bit is taken by doing a majority voting of

the logic value to the three samples in the center of the received bit. The center samples

are emphasized on the figure by having the sample number inside boxes. The majority

voting process is done as follows: If two or all three samples have high levels, the

received bit is registered to be a logic 1. If two or all three samples have low levels, the

received bit is registered to be a logic 0. This majority voting process acts as a low pass

filter for the incoming signal on the RxD pin. The recovery process is then repeated until

a complete frame is received. Including the first stop bit. Note that the Receiver only

uses the first stop bit of a frame.

START

IDLE

BIT 0

123

678

RxDn

Sample

(U2Xn = 0)

Sample

(U2Xn = 1)

BIT x

123

678

RxDn

Sample

(U2Xn = 0)

Sample

(U2Xn = 1)

AT90PWM2 Datasheet(PDF) 207 Page - ATMEL Corporation

AT90PWM2 Datasheet(HTML) 207 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL