STA333BW datasheet(24/64 Pages) STMICROELECTRONICS

24 / 64 page

STA333BW

24/64

6.1.3

Thermal warning recovery bypass

If the thermal warning adjustment is enabled (TWAB=0), then the thermal warning recovery

determines if the -3 dB output limit is removed when thermal warning is negative.

If TWRB=0 and TWAB=0, then when a thermal warning disappears the -3 dB output limit is

removed and the gain is added back to the system. If TWRB=1 and TWAB=0, then when a

thermal warning disappears the -3 dB output limit remains until TWRB is changed to zero or

the device is reset.

6.1.4

Thermal warning adjustment bypass

The on-chip STA333BW power output block provides feedback to the digital controller using

inputs to the power control block. The TWARN input is used to indicate a thermal warning

condition. When TWARN is asserted (set to 0) for a period of time greater than 400 ms, the

power control block forces a -3 dB output limit (determined by TWOCL in Coeff RAM) to the

modulation limit in an attempt to eliminate the thermal warning condition. Once the thermal

warning output limit adjustment is applied, it remains in this state until reset, unless

FDRB = 0.

6.1.5

Fault detect recovery bypass

The on-chip STA333BW power output block provides feedback to the digital controller using

inputs to the power control block. The FAULT input is used to indicate a fault condition (either

over-current or thermal). When FAULT is asserted (set to 0), the power control block

attempts a recovery from the fault by asserting the tri-state output (setting it to 0 which

directs the power output block to begin recovery), holds it at 0 for period of time in the range

of 0.1 ms to 1 second as defined by the fault-detect recovery constant register (FDRC

registers 0x29, 0x2A), then toggles it back to 1. This sequence is repeated as log as the

fault indication exists. This feature is enabled by default but can be bypassed by setting the

FDRB control bit to 1.

Bit

R/W

RST

Name

Description

5R/W

TWRB

0: thermal warning recovery enabled

1: thermal warning recovery disabled

Bit

R/W

RST

Name

Description

6R/W

TWAB

0: thermal warning adjustment enabled

1: thermal warning adjustment disabled

Bit

R/W

RST

Name

Description

7R/W

FDRB

0: fault detect recovery enabled

1: fault detect recovery disabled

STA333BW Datasheet(PDF) 24 Page - STMicroelectronics

STA333BW Datasheet(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Download

Link URL