| Electronic Components Datasheet Search |
|
XC2000 Datasheet(PDF) 83 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
XC2000 Datasheet(HTML) 83 Page - Infineon Technologies AG |
|
83 / 110 page ![]() XC2287 / XC2286 / XC2285 XC2000 Family Derivatives Electrical Parameters Preliminary Data Sheet 81 V0.91, 2007-02 Draft Version 4.2.3 Power Consumption The amount of power that is consumed by the XC228x depends on several factors, such as supply voltage, operating frequency, amount of active circuitry, and operating temperature. Part of this depends on the device’s activity (switching current), part of this is independent (leakage current). Therefore, the leakage current must be added to all other (frequency-dependent) parameters. For additional information, please refer to Section 5.2, Thermal Considerations. Table 14 Power Consumption XC228x (Operating Conditions apply) Parameter Sym- bol Values Unit Note / Test Condition Min. Typ. Max. Supply current caused by leakage 1) (DMP_1 powered) 1) The supply current caused by leakage mainly depends on the junction temperature (see Figure 12) and the supply voltage. The temperature difference between the junction temperature T J and the ambient temperature T A must be taken into account. As this fraction of the supply current does not depend on the device’s activity, it must be added to each other power consumption parameter. I DDL – 600,000 × e-α tbd mA V DDP = VDDPmax 2) α = 5000 / (273 + T J), T J in [°C] 2) All inputs (including pins configured as inputs) at 0 V to 0.1 V or at V DDP - 0.1 V to VDDP, all outputs (including pins configured as outputs) disconnected. This parameter is tested at 25 °C and is valid for T J ≥ 25 °C. Supply current caused by leakage 1) (DMP_1 switched off) I DDL – 500,000 × e-α tbd µA V DDP = VDDPmax 2) α = 3000 / (273 + T J), T J in [°C] Power supply current (active) with all peripherals active and EVVRs on I DDP – 10 + 0.6 ×f SYS tbd mA Active Mode 3) f SYSin [MHz] 3) The pad supply voltage pins ( V DDP) provide the input current for the on-chip EVVRs and the current consumed by the pin output drivers. A small amount of current is consumed because the drivers’ input stages are switched. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |