TCM4400EPET datasheet(50/64 Pages) TI

50 / 64 page

TCM4400E

GSM/DCS BASEBAND AND VOICE A/D

AND D/A RF INTERFACE CIRCUIT

SLWS082A – JULY 1999 – REVISED MARCH 2000

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

PRINCIPLES OF OPERATION

baseband control register (see Table 15)

The values in the baseband control register bit positions determine whether the data is shifted left or right. Note

that the microcontroller unit (MCU) clocking scheme determines on which edge of the clock that data is received

or transmitted using the serial interface.

Table 15. Baseband Control Register

BCTLREG: BASEBAND CONTROL REGISTER

ADDRESS: 9

R/W

RESERVD

MCLKBP

BCLKMODE

BIZBUS

BCLKDIR

UDIR

UPHA

UPOL

1/0

R = 0

R /W

R/W

<–ACCESS TYPE

<–VALUE AT RESET

UDIR:

This bit determines whether the data is shifted in from right (see serial register description) to

left, MSB first (bit value 0), or from left to right, LSB first (bit value 1).

BCLKMODE:When cleared to 0, BLCKX runs in the burst mode; when set to 1, BCLKX is continuous.

MCLKBP:

When cleared to 0, MCLK signal passes through the clock slicer; when set to 1, the clock slicer

is bypassed (in this case, the signal at the MCLK terminal must be digital).

MCU clocking schemes

Falling edge without delay: The MCU serial interface transmits data on the falling edge of the UCLK and

receives data on the rising edge of UCLK.

Falling edge with delay:

The MCU serial interface transmits data one half-cycle ahead of the falling edge

of the UCLK and receives data on the falling edge of the UCLK.

Rising edge without delay: The MCU serial interface transmits data on the rising edge of the UCLK and

receives data on the falling edge of the UCLK.

Rising edge with delay:

The MCU serial interface transmits data one half-cycle ahead of the rising edge

of the UCLK and receives data on the rising edge of UCLK.

Table 16. MCU Clocking Schemes

UPOL

UPHA

MCU CLOCKING SCHEME

Falling edge without delay

Falling edge with delay

Rising edge without delay

Rising edge with delay

BCLKDIR:

Direction of the BCLKR port ( 0 –> Output, 1–> Input).

BIZBUS:

When set to 1, BDX, BCLKX, BFSX are in hi-Z when there is nothing to transfer to the DSP;

when cleared to 0, DBX, BCLKX, BFSX are set to VSS when there is nothing to transfer to the

DSP.

RESRVD:

Reserved bits for testing purpose

TCM4400EPET Datasheet(PDF) 50 Page - Texas Instruments

TCM4400EPET Datasheet(HTML) 50 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Download

Link URL