ACE25C200

2MB Serial Flash Memory

VER 1.2

9

Status Register Protect bit / Lock_bit (SRP/LB)

The Status Register Protect (SRP) bit is operated in conjunction with the Write Protect (WP#) signal.

The Status Register Write Protect (SRP) bit and Write Protect (WP#) signal allow the device to be put

in the Hardware Protected mode (when the Status Register Protect (SRP) bit is set to 1, and Write

Protect (WP#) is driven Low). In this mode, the non-volatile bits of the Status Register (SRP, BP2,

BP1, BP0) become read-only bits and the Write Status Register (WRSR) instruction is no longer

accepted for execution.

In OTP mode, this bit is served as Lock_bit (LB), user can read/program/erase security sector as

normal sector while LB value is equal 0, after LB is programmed with 1 by WRSR command, the

security sector is protected from program and erase operation. The LB can only be programmed once.

Note: In OTP mode, the WRSR command will ignore any input data and program LB to 1, user must clear the protect bits

before enter OTP mode and program the OTP code, then execute WRSR command to lock the security sector before

leaving OTP mode.

Status Register Memory Protection

Status Register Content

Memory Content

BP2 bit

BP1 bit

BP0 bit

Protect Areas

Address

Density

Portion

0

0

0

None

None

None

None

0

0

1

Reserved State, not allowed

0

1

0

0

1

1

1

0

0

Sector 0~47

000000h~02FFFFh

192KB

Lower 48/64

1

0

1

Sector 0~31

000000h~01FFFFh

128KB

Lower 32/64

1

1

0

All

000000h~02FFFFh

256KB

All

1

1

1

All

000000h~03FFFFh

256KB

All

Instructions

The Standard/Dual SPI instruction set of the ACE25C200 consists of 17 basic instructions that are

fully controlled through the SPI bus (see Table 4~Table 5 Instruction Set). Instructions are initiated

with the falling edge of Chip Select (CS#). The first byte of data clocked into the DI input provides the

instruction code. Data on the DI input is sampled on the rising edge of clock with most significant bit

(MSB) first.

Instructions vary in length from a single byte to several bytes and may be followed by address bytes,

data byte

s, dummy bytes (don’t care), and in some cases, a combination. Instructions are completed

with the rising edge of edge CS#. Clock relative timing diagrams for each instruction are included in

Figure 5 through Figure 27. All read instructions can be complet ed after any clocked bit. However, all

instructions that Write, Program or Erase must complete on a byte boundary (CS# driven high after a

full 8-bits have been clocked) otherwise the instruction will be ignored. This feature further protects

the device from inadvertent writes. Additionally, while the memory is being programmed or erased, or

when the Status Register is being written, all instructions except for Read Status Register will be

ignored until the program or erase cycle has completed.