TSC2014IYZGR datasheet(39/62 Pages) TI2

39 / 62 page

TSC2014

www.ti.com

SBAS484B – SEPTEMBER 2010 – REVISED DECEMBER 2016

Product Folder Links: TSC2014

Submit Documentation Feedback

7.6.3 Control Byte 1

Figure 38. Control Byte Format:

Start a Conversion and Mode Setting

MSB

LSB

(Control Byte 1)

SWRST

STS

LEGEND: R/W = Read/Write; R = Read only; -n = value after reset

Table 8. Control Byte 1 Bit Register Description (D7 = 1)

Bit

Field

Type

Reset

Description

Control Byte ID

R/W

0000h

1: Control Byte 1 (start conversion and channel select and

conversion-related configuration).

0: Control Byte 0 (read/write data registers and non-conversion-

related controls).

0000h

Converter function select bits. These bits select the input to be

converted, and the converter function to be executed. Table 9

lists the possible converter functions.

0000h

R/W

0000h

0: 10 Bit

1: 12 Bit

SWRST

R/W

0000h

Software Reset. This bit is self-clearing.

1: Reset all register values to default

STS

R/W

0000h

Stop bit for all converter functions. This bit is self-clearing.

Table 9. Converter Function Select

FUNCTION

Touch screen scan function: X, Y, Z1, and Z2 coordinates converted and the results returned

to X, Y, Z1, and Z2 data registers. Scan continues until either the pen is lifted or a stop bit is

sent.

Touch screen scan function: X and Y coordinates converted and the results returned to X and

Y data registers. Scan continues until either the pen is lifted or a stop bit is sent.

Touch screen scan function: X coordinate converted and the results returned to X data

Touch screen scan function: Y coordinate converted and the results returned to Y data

Touch screen scan function: Z1 and Z2 coordinates converted and the results returned to Z1

and Z2 data registers.

Auxiliary input converted and the results returned to the AUX data register.

A temperature measurement is made and the results returned to the Temperature

Measurement 1 data register.

A differential temperature measurement is made and the results returned to the Temperature

Measurement 2 data register.

Auxiliary input is converted continuously and the results returned to the AUX data register.

Touch screen panel connection to X-axis drivers is tested. The test result is output to

PINTDAV and shown in STATUS register.

Touch screen panel connection to Y-axis drivers is tested. The test result is output to

PINTDAV and shown in STATUS register.

RESERVED (Note: any condition caused by this command can be cleared by setting the STS

bit to 1).

Touch screen panel short-circuit (between X and Y plates) is tested through Y-axis. The test

result is output to PINTDAV and shown in the STATUS register.

X+, X– drivers status

Y+, Y– drivers status

Y+, X– drivers status

TSC2014IYZGR Datasheet(PDF) 39 Page - Texas Instruments

TSC2014IYZGR Datasheet(HTML) 39 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Datasheet Download

Link URL