| Electronic Components Datasheet Search |
|
SH7032 Datasheet(PDF) 79 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
SH7032 Datasheet(HTML) 79 Page - Renesas Technology Corp |
|
79 / 687 page ![]() Section 4 Exception Handling Rev. 7.00 Jan 31, 2006 page 53 of 658 REJ09B0272-0700 4.1.2 Exception Handling Operation Exception sources are detected at the times indicated in table 4.1, whereupon handling starts. Table 4.1 Exception Source Detection and Start of Handling Exception Type Source Detection and Start of Handling Reset Power-on Low-to-high transition at RES pin when NMI is high Manual Low-to-high transition at RES pin when NMI is low Address error Detected when instruction is decoded and starts after the instruction that was executing prior to this point is completed. Interrupt Detected when instruction is decoded and starts after the instruction that was executing prior to this point is completed. Instruction Trap instruction Starts when a trap instruction (TRAPA) is executed. General illegal instruction Starts when undefined code is decoded at a position other than directly after a delayed branch instruction (a delay slot). Illegal slot instruction Starts when undefined code or an instruction that rewrites the PC is decoded directly after a delayed branch instruction (in a delay slot). When exception handling begins, the CPU operates as follows: Resets: The initial values of the program counter (PC) and stack pointer (SP) are read from the exception vector table (the respective PC and SP values are H'00000000 and H'00000004 for a power-on reset and H'00000008 and H'0000000C for a manual reset). For more information on the exception vector table, see section 4.1.3, Exception Vector Table. Next, the vector base register (VBR) is cleared to zero and interrupt mask bits (I3–I0) in the status register (SR) are set to 1111. Program execution starts from the PC address read from the exception vector table. Address Errors, Interrupts and Instructions: SR and PC are pushed onto the stack indicated in R15. For interrupts, the interrupt priority level is written in the interrupt mask bits (I3–I0). For address errors and instructions, bits I3–I0 are not affected. Next, the start address is fetched from the exception vector table, and program execution starts from this address. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |