PC87393F datasheet(55/148 Pages) NSC

55 / 148 page

2.0 Device Architecture and Configuration (Continued)

www.national.com

2.14 SERIAL PORT 1 CONFIGURATION

2.14.1

Logical Device 3 (SP1) Configuration

Table 22 lists the configuration registers which affect the Serial Port 2. Only the last register (F0h) is described here. See

Sections 2.2.3 and 2.2.4 for descriptions of the others.

Table 22. Serial Port 1 Conﬁguration Registers

2.14.2

Serial Port 1 Configuration Register

This register is reset by hardware to 02h.

Location:

Index F0h

Type:

R/W

Index

Conﬁguration Register or Action

Type

Reset

30h Activate. See also bit 0 of the SIOCF1 register and bit 3 of the SIOCF6 register. R/W

00h

60h Base Address MSB register. Bits 7-3 (for A15-11) are read only, 00000b.

R/W

03h

61h Base Address LSB register. Bit 2-0 (for A2-0) are read only, 000b.

R/W

F8h

70h Interrupt Number and Wake-Up on IRQ Enable register

R/W

04h

71h Interrupt Type. Bit 1 is R/W; other bits are read only.

R/W

03h

74h Report no DMA Assignment

04h

75h Report no DMA Assignment

04h

F0h Serial Port 1 Conﬁguration register

R/W

02h

Bit

76543210

Name

Bank

Select

Enable

Reserved

Busy

Indicator

Power

Mode

Control

TRI-STATE

Control

Reset

00000010

Bit

Description

Bank Select Enable. Enables bank switching for Serial Port 1.

0: Disabled (default).

1: Enabled

6-3

Reserved

Busy Indicator. This read only bit can be used by power management software to decide when to power-down

the Serial Port 1 logical device.

0: No transfer in progress (default).

1: Transfer in progress.

Power Mode Control. When the logical device is active in:

0: Low power mode

Serial Port 1 clock disabled. The output signals are set to their default states. The RI input signal can be

programmed to generate an interrupt. Registers are maintained (unlike Active bit in Index 30 that also

prevents access to Serial Port 1 registers).

1: Normal power mode

Serial Port 1 clock enabled. Serial Port 1 is functional when the logical device is active (default).

TRI-STATE Control. When enabled and the device is inactive, the logical device output pins are in TRI-STATE.

0: Disabled (default)

1: Enabled

PC87393F Datasheet(PDF) 55 Page - National Semiconductor (TI)

PC87393F Datasheet(HTML) 55 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL