HD64F7047 datasheet(329/764 Pages) RENESAS

329 / 764 page

Rev. 2.00, 09/04, page 289 of 720

Operation when Error Occurs during PWM Mode 2 Operation, and Operation is Restarted

in Normal Mode: Figure 10.97 shows an explanatory diagram of the case where an error occurs

in PWM mode 2 and operation is restarted in normal mode after re-setting.

RESET

TMDR

(PWM2)

TIOR

(1 init

0 out)

TSTR

(1)

PFC

(MTU)

Match

Error

occurs

PFC

(PORT)

TSTR

(0)

TMDR

(normal)

TIOR

(1 init

0 out)

PFC

(MTU)

TSTR

(1)

MTU module

output

TIOC*A

TIOC*B

Port output

PEn

• Not initialized (cycle register)

n=0 to 15

High-Z

Figure 10.97 Error Occurrence in PWM Mode 2, Recovery in Normal Mode

After a reset, MTU output is low and ports are in the high-impedance state.

Set PWM mode 2.

Initialize the pins with TIOR. (The example shows initial high output, with low output on

compare-match occurrence. In PWM mode 2, the cycle register pins are not initialized. In the

example, TIOC *A is the cycle register.)

Set MTU output with the PFC.

The count operation is started by TSTR.

Output goes low on compare-match occurrence.

An error occurs.

Set port output with the PFC and output the inverse of the active level.

The count operation is stopped by TSTR.

10. Set normal mode.

11. Initialize the pins with TIOR.

12. Set MTU output with the PFC.

13. Operation is restarted by TSTR.

HD64F7047 Datasheet(PDF) 329 Page - Renesas Technology Corp

HD64F7047 Datasheet(HTML) 329 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL