LPC4370 datasheet(3/150 Pages) NXP

3 / 150 page

LPC4370

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 2 — 21 October 2013

3 of 150

NXP Semiconductors

LPC4370

32-bit ARM Cortex-M4/M0 microcontroller

 LCD controller with DMA support and a programmable display resolution of up to

1024 H

 768 V. Supports monochrome and color STN panels and TFT color

panels; supports 1/2/4/8 bpp Color Look-Up Table (CLUT) and 16/24-bit direct pixel

mapping.

 Secure Digital Input Output (SD/MMC) card interface.

 Eight-channel General-Purpose DMA (GPDMA) controller can access all memories

on the AHB and all DMA-capable AHB slaves.

 164 General-Purpose Input/Output (GPIO) pins with configurable pull-up/pull-down

resistors and open-drain mode.

 GPIO registers are located on the AHB for fast access. GPIO ports have DMA

support.

 Up to eight GPIO pins can be selected from all GPIO pins as edge and level

sensitive interrupt sources.

 Two GPIO group interrupt modules enable an interrupt based on a programmable

pattern of input states of a group of GPIO pins.

 Four general-purpose timer/counters with capture and match capabilities.

 One motor control Pulse Width Modulator (PWM) for three-phase motor control.

 One Quadrature Encoder Interface (QEI).

 Repetitive Interrupt timer (RI timer).

 Windowed watchdog timer (WWDT).

 Ultra-low power Real-Time Clock (RTC) on separate power domain with 256 bytes

of battery powered backup registers.

 Alarm timer; can be battery powered.

 Analog peripherals

 One 10-bit DAC with DMA support and a data conversion rate of 400 kSamples/s.

LBGA256 package only.

 Two 8-channel, 10-bit ADCs (ADC0/1) with DMA support and a data conversion

rate of 400 kSamples/s for a total of 16 independent channels. The 10-bit ADCs

are only available on the LBGA256 package.

 One 6-channel, 12-bit high-speed ADC (ADCHS) with DMA support and a data

conversion rate of 80 MSamples/s.

 Unique ID for each device.

 Clock generation unit

 Crystal oscillator with an operating range of 1 MHz to 25 MHz.

 12 MHz Internal RC (IRC) oscillator trimmed to 1 % accuracy over temperature and

voltage.

 Ultra-low power Real-Time Clock (RTC) crystal oscillator.

 Three PLLs allow CPU operation up to the maximum CPU rate without the need for

a high-frequency crystal. The second PLL is dedicated to the High-speed USB, the

third PLL can be used as audio PLL.

 Clock output.

 Power

 Single 3.3 V (2.2 V to 3.6 V) power supply with on-chip DC-to-DC converter for the

core supply and the RTC power domain.

 RTC power domain can be powered separately by a 3 V battery supply.

 Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deep

power-down.

LPC4370 Datasheet(PDF) 3 Page - NXP Semiconductors

LPC4370 Datasheet(HTML) 3 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL