C165 datasheet(71/77 Pages) INFINEON

71 / 77 page

C165

Data Sheet

V2.0, 2000-12

Figure 21

CLKOUT and READY

Notes

1) Cycle as programmed, including MCTC waitstates (Example shows 0 MCTC WS).

2) The leading edge of the respective command depends on RW-delay.

3) READY sampled HIGH at this sampling point generates a READY controlled waitstate,

READY sampled LOW at this sampling point terminates the currently running bus cycle.

4) READY may be deactivated in response to the trailing (rising) edge of the corresponding command (RD or

WR).

5) If the Asynchronous READY signal does not fulfill the indicated setup and hold times with respect to CLKOUT

(e.g. because CLKOUT is not enabled), it must fulfill

t37 in order to be safely synchronized. This is guaranteed,

if READY is removed in response to the command (see Note 4)).

6) Multiplexed bus modes have a MUX waitstate added after a bus cycle, and an additional MTTC waitstate may

be inserted here.

For a multiplexed bus with MTTC waitstate this delay is 2 CLKOUT cycles, for a demultiplexed bus without

MTTC waitstate this delay is zero.

7) The next external bus cycle may start here.

MCT04447

CLKOUT

ALE

Command

RD, WR

Sync

READY

Async

READY

see 6)

Running Cycle 1)

READY

Waitstate

MUX/Tristate 6)

C165 Datasheet(PDF) 71 Page - Infineon Technologies AG