DIX9211 datasheet(12/110 Pages) TI2

12 / 110 page

DIX9211

SBAS519 – SEPTEMBER 2010

www.ti.com

Auxiliary PCM Audio Input and Output (I/O)

There are up to 3x digital auxiliary (AUX) inputs and one AUX output on the DIX9211. These I/Os are multiplexed

and shared with RXIN4 through RXIN7, MPIOB, and MPIOC. Each input and output supports a four-wire digital

audio interface that is similar to the I2S protocol. Each I/O can support SCK (system clock), BCK (bit clock),

LRCK (left/right clock, or word clock) and data transmissions. The audio format supported through the Aux I/O

can be configured for I2S, 24-bit left-justified (LJ), 24-bit right-justified (RJ), and 16-bit RJ output.

The AUX inputs are designed to be driven in Clock Slave mode. The Aux Output can only operate in Master

mode. The system clock can be run from 128fS, 256fS, and 512fS.

Routing

All 3x AUXIN data and clocks, in addition to data and clocks from the DIR module, are routed to three output

ports. The Main Output Port and Aux Output Port (that can be output through MPIO_B) are both PCM outputs

capable of I2S, RJ, and LJ. The DIT output is an S/PDIF signal output.

All three outputs have individual multiplexers that can select between the AUXINs or DIR.

Control Interface

The DIX9211 can be controlled by either SPI or I2C (up to a 400-kHz I2C bus). However, on startup, the device

goes into a default routing mode. Details of this mode are discussed in the Serial Control Mode section. For

certain applications, the default configuration may be suitable, and therefore does not require external

programming.

Multipurpose I/O

The DIX9211 includes 12 MPIO (Multi-Purpose Inputs/Outputs) and two MPO (Multi-Purpose Output) pins.

These MPIO/MPO pins can be easily set to different configurations through registers to allow different routing

and provide data outputs based on the specific application.

The 12 MPIO pins are divided into three groups (A, B, and C); each group has four pins (MPIO_Ax, MPIO_Bx,

and MPIO_Cx).

For example, to access all 12 S/PDIF inputs, the MPIO_Ax pins can be configured to support S/PDIF RXIN8 and

RXIN11. However, if the application requires an additional I2S input, then the MPIO_Ax pins can be configured

for an Aux In instead of RXIN8 and RXIN11.

Submit Documentation Feedback

Product Folder Link(s): DIX9211

DIX9211 Datasheet(PDF) 12 Page - Texas Instruments