HD64F36034 datasheet(121/592 Pages) RENESAS

121 / 592 page

Section 7 ROM

Rev. 4.00 Mar. 15, 2006 Page 89 of 556

REJ09B0026-0400

Section 7 ROM

The features of the 56-kbyte or 32-kbyte flash memories built into the flash memory (F-ZTAT)

version are summarized below.

• Programming/erase methods

 The flash memory is programmed 128 bytes at a time. Erase is performed in single-block

units. The flash memory is configured as follows: 1 kbyte

× 4 blocks, 28 kbytes × 1 block,

16 kbytes

× 1 block, and 8 kbytes × 1 block for the H8/36057F and H8/36037F and 1 kbyte

× 4 blocks and 28 kbytes × 1 block for the H8/36054F and H8/36034F. To erase the entire

flash memory, each block must be erased in turn.

• Reprogramming capability

 The flash memory can be reprogrammed up to 1,000 times.

• On-board programming

 On-board programming/erasing can be done in boot mode, in which the boot program built

into the chip is started to erase or program of the entire flash memory. In normal user

program mode, individual blocks can be erased or programmed.

• Programmer mode

 Flash memory can be programmed/erased in programmer mode using a PROM

programmer, as well as in on-board programming mode.

• Automatic bit rate adjustment

 For data transfer in boot mode, this LSI's bit rate can be automatically adjusted to match

the transfer bit rate of the host.

• Programming/erasing protection

 Sets software protection against flash memory programming/erasing.

• Power-down mode

 Operation of the power supply circuit can be partly halted in subactive mode. As a result,

flash memory can be read with low power consumption.

7.1

Block Configuration

Figure 7.1 shows the block configuration of flash memory. The thick lines indicate erasing units,

the narrow lines indicate programming units, and the values are addresses. The 56-kbyte flash

memory is divided into 1 kbyte

× 4 blocks, 28 kbytes × 1 block, 16 kbytes × 1 block, and 8 kbytes

× 1 block. The 32-kbyte flash memory is divided into 1 kbyte × 4 blocks and 28 kbytes × 1 blocks.

Erasing is performed in these units. Programming is performed in 128-byte units starting from an

address with lower eight bits H'00 or H'80.

HD64F36034 Datasheet(PDF) 121 Page - Renesas Technology Corp