| Electronic Components Datasheet Search |
|
ISM330BXTR Datasheet(PDF) 52 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ISM330BXTR Datasheet(HTML) 52 Page - STMicroelectronics |
|
52 / 150 page ![]() 9 Register description The device contains a set of registers which are used to control its behavior and to retrieve linear acceleration, angular rate, temperature and Qvar data. The register addresses, made up of 7 bits, are used to identify them and to write the data through the serial interface. 9.1 FUNC_CFG_ACCESS (01h) Enable embedded functions register (R/W) Table 25. FUNC_CFG_ACCESS register EMB_FUNC_ REG_ACCESS 0(1) 0(1) 0(1) FSM_WR_ CTRL_EN SW_POR 0(1) 0(1) 1. This bit must be set to 0 for the correct operation of the device. Table 26. FUNC_CFG_ACCESS register description EMB_FUNC_REG_ACCESS Enables access to the embedded functions configuration registers. (1) Default value: 0 FSM_WR_CTRL_EN Enables the control of the CTRL registers to FSM (FSM can change some configurations of the device autonomously). Default value: 0 (0: disabled; 1: enabled) SW_POR Global reset of the device. Default value: 0 1. Details concerning the embedded functions configuration registers are available in Section 10: Embedded functions register mapping and Section 11: Embedded functions register description. 9.2 PIN_CTRL (02h) WCLK and SDO pin pull-up register (R/W). This register is not reset during the software reset procedure (see bit 0 of the CTRL3 (12h) register). Table 27. PIN_CTRL register TDM_WCLK _PU_DIS SDO_ PU_EN IBHR_ POR_EN 0(1) 0(1) 0(1) 1(2) 1(2) 1. This bit must be set to 0 for the correct operation of the device. 2. This bit must be set to 1 for the correct operation of the device. Table 28. PIN_CTRL register description TDM_WCLK_PU_DIS Disables pull-up on WCLK pin. Default value: 0 (0: WCLK pin with pull-up; 1: WCLK pin pull-up disconnected) SDO_PU_EN Enables pull-up on SDO pin. Default value: 0 (0: SDO pin pull-up disconnected; 1: SDO pin with pull-up) IBHR_POR_EN Selects the action the device performs after "reset whole chip" I3C pattern. Default value: 1 (0: configuration reset (software reset + dynamic address reset); (1: global reset (POR reset)) ISM330BX Register description DS14588 - Rev 2 page 52/150 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |