CS5530A datasheet(39/259 Pages) AMD

39 / 259 page

AMD Geode™ CS5530A Companion Device Data Book

Signal Definitions

Revision 1.1

3.2.8

USB Interface

Signal Name

No.

Type

Description

POWER_EN

Power Enable

This pin enables the power to a self-powered USB hub.

OVER_CUR#

Over Current

This pin indicates the USB hub has detected an overcurrent on the USB.

D+_PORT1

I/O

USB Port 1 Data Positive

This pin is the Universal Serial Bus Data Positive for port 1.

D–_PORT1

I/O

USB Port 1 Data Minus

This pin is the Universal Serial Bus Data Minus for port 1.

D+_PORT2

AA2

I/O

USB Port 2 Data Positive

This pin is the Universal Serial Bus Data Positive for port 2.

D–_PORT2

AA1

I/O

USB Port 2 Data Minus

This pin is the Universal Serial Bus Data Minus for port 2.

VDD_USB

PWR

Power for USB

AVDD_USB

AB4

Analog

Analog Power for USB

AVSS_USB

AA4

Analog

Analog Ground for USB

3.2.9

Game Port and General Purpose I/O Interface

Signal Name

No.

Type

Description

GPORT_CS#

AD21

Game Port Chip Select

GPORT_CS# is asserted upon any I/O reads or I/O writes to I/O Port 200h

and 201h.

GPCS#

AF26

General Purpose Chip Select

GPCS# is asserted upon any I/O access that matches the I/O address in the

General Purpose Chip Select Base Address Register (F0 Index 70h) and

the conditions set in the General Purpose Chip Select Control Register (F0

Index 72h).

GPIO7/SA23

AF23

I/O

Limited ISA Mode: General Purpose I/Os 7 through 4 or

System Address Bus Lines 23 through 20

These pins can function either as general purpose I/Os or as the upper four

bits of the SA bus. Selection is done through F0 Index 43h[6,2].

Refer to GPIO[3:2] signal description for GPIO function description.

GPIO6/SA22

AE23

GPIO5/SA21

AC21

GPIO4/SA20

AD22

ISA Master Mode: System Address Bus Lines 23 through 20

These pins function as the four MSB (most significant bits) of the SA bus.

GPIO3

AF24

I/O

General Purpose I/Os 3 and 2

GPIOs can be programmed to operate as inputs or outputs via F0 Index

90h. As an input, the GPIO can be configured to generate an external SMI.

Additional configuration can select if the SMI# is generated on the rising or

falling edge. GPIO external SMI generation/edge selection is done in F0

Index 92h and 97h.

GPIO2

AF25

I/O

CS5530A Datasheet(PDF) 39 Page - Advanced Micro Devices

CS5530A Datasheet(HTML) 39 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL