PC7410 datasheet(53/57 Pages) ETC2

53 / 57 page

0832F–HIREL–02/07

e2v semiconductors SAS 2007

PC7410

17. Document Revision History

Table 17-1 provides a revision history for this hardware specification.

Table 17-1.

Document Revision History

Rev. No

Date

Substantive Change(s)

01/07

Name change from Atmel to e2v

10/2004

Table 8-1 on page 18: Changed note 1 to specify that OVDD and L2OVDD power is typically < 5% of VDD power

Figure 12-5 on page 37: revised diagram and dimensions to specify ‘cap regions’ versus individual cap

measurements. Moved individual capacitor placement to separate figure

Figure 12-6 on page 38: Added this figure to show each individual capacitor placement and value

Figure 14-5 on page 47: updated COP Connector Diagram to recommend a weak pull-up resistor on TCK

Table 9-1 on page 19: Changed measurement test condition IOH from -6mA to -5 mA for VOH and IOL from 6

mA to 5 mA for VOL per product bulletin

“PLL and DLL Power Supply Filtering” on page 43: revised text regarding AV

DD filter selection for the CBGA

package

Product specification release subsequent to product qualification

Motorola changed to Freescale

02/2004

Figure 12-5 on page 37: added package capacitor values

Section "Thermal Management Assistant": deleted

Section “Pull-up Resistor Requirements” on page 47: added recommendation that strong pull-up/down

resistors be used on the PLL_CFG[0:3] signals

Table 9-3 on page 21: removed mode input setup and hold times. These inputs adhere to the general input

setup and hold specifications

Figure 9-4 on page 24: revised mode input diagram to show sample points around HRESET negation

Figure 14-6 on page 50: added note 6 to emphasize that COP emulator and target board need to be able to

drive HRESET and TRST independently to the CPU

Section “PLL and DLL Power Supply Filtering” on page 43: revised section for HCTE package. Added text and

figure for AV

DD filter for the CBGA package

Section “Pull-up Resistor Requirements” on page 47: removed AACK, TEA, and TS from control signals

requiring pull-ups. Removed TBST from snooped transfer attribute list. TBST is an output and is not snooped

PC7410 Datasheet(PDF) 53 Page - List of Unclassifed Manufacturers