ATtiny48 datasheet(39/266 Pages) ATMEL

39 / 266 page

8008C–AVR–03/09

ATtiny48/88

System Control and Reset

8.1

Resetting the AVR

During reset, all I/O Registers are set to their initial values, and the program starts execution

from the Reset Vector. The instruction placed at the Reset Vector must be an RJMP – Relative

Jump – instruction to the reset handling routine. If the program never enables an interrupt

source, the Interrupt Vectors are not used, and regular program code can be placed at these

locations. The circuit diagram in Figure 8-1 shows the reset circuit. Table 21-3 on page 204

shows the electrical parameters of the reset circuitry.

Figure 8-1.

Reset Logic

The I/O ports of the AVR are immediately reset to their initial state when a reset source goes

active. This does not require any clock source to be running.

After all reset sources have gone inactive, a delay counter is invoked, stretching the internal

reset. This allows the power to reach a stable level before normal operation starts. The time-out

period of the delay counter is defined by the user through the SUT and CKSEL Fuses. The dif-

ferent selections for the delay period are presented in “Clock Sources” on page 26.

MCU Status

Brown-out

Reset Circuit

BODLEVEL [2..0]

Delay Counters

CKSEL[1:0]

TIMEOUT

DATA BUS

Clock

Generator

SPIKE

FILTER

Pull-up Resistor

Watchdog

Oscillator

SUT[1:0]

Power-on Reset

Circuit

ATtiny48 Datasheet(PDF) 39 Page - ATMEL Corporation