AM8530 datasheet(134/194 Pages) AMD

134 / 194 page

AMD

6–24

D7 D6 D5 D4 D3 D2 D1 D0

Receive Clock = RTxC Pin

Receive Clock = TRxC Pin

Receive Clock = BR Generator Output

Receive Clock = DPLL Output

TRxC Out = XTAL Output

TRxC Out = Transmit Clock

TRxC Out = BR Generator Output

TRxC Out = DPLL Output

Transmit Clock = RTxC Pin

Transmit Clock = TRxC Pin

Transmit Clock = BR Generator Output

Transmit Clock = DPLL Output

TRxC O/I

RTxC XTAL/NO XTAL

Figure 6–13. Write Register 11

Bit 7: RTxC—XTAL/NO XTAL

This bit controls the type of input signal the SCC expects to see on the

RTxC pin. If this

bit is set to ‘0’, the SCC expects a TTL-compatible signal as an input to this pin. If this bit

is set to ‘1’, the SCC connects a high-gain amplifier between the

RTxC and SYNC pins in

expectation of a quartz crystal being placed across the pins.

The output of this oscillator is available for use as a clocking source. In this mode of op-

eration, the Sync pin is unavailable for other use. The Sync signal is forced to ‘0’ inter-

nally. A hardware reset forces No XTAL. (At least 20 ms should be allowed after this bit is

set to allow the oscillator to stabilize.)

Bits 6 and 5: Receiver Clock 1 And 0

These bits determine the source of the receive clock as shown in Table 6–6. They do not

interfere with any of the modes of operation in the SCC but simply control a multiplexer

just before the internal receive clock input. A hardware reset forces the receive clock to

come from the

TRxC pin.

Table 6–6. Receive Clock Source

Receive Clock = RTxC pin

Receive Clock =

TRxC pin

Receive Clock = BRG output

Receive Clock = DPLL output

AM8530 Datasheet(PDF) 134 Page - Advanced Micro Devices