SH7101 datasheet(303/560 Pages) RENESAS

303 / 560 page

Section 8 Multifunction Timer Pulse Unit (MTU)

Rev.1.00 Sep. 18, 2008 Page 269 of 522

REJ09B0069-0100

Output-Level Compare Operation

Figure 8.115 shows an example of the output-level compare operation for the combination of

PE9/TIOC3B and PE11/TIOC3D. The operation is the same for the other pin combinations.

PE11/

TIOC3D

PE9/

TIOC3B

0 level overlapping detected

High impedance state

Figure 8.115 Output-Level Detection Operation

Release from High-Impedance State

High-current pins that have entered high-impedance state due to input-level detection can be

released either by returning them to their initial state with a power-on reset, or by clearing all of

the bit 12 to 15 (POE0F to POE3F) flags of the ICSR1. High-current pins that have become high-

impedance due to output-level detection can be released either by returning them to their initial

state with a power-on reset, or by first clearing bit 9 (OCE) of the OCSR to disable output-level

compares, then clearing the bit 15 (OSF) flag. However, when returning from high-impedance

state by clearing the OSF flag, always do so only after outputting a high level from the high-

current pins (TIOC3B, TIOC3D, TIOC4A, TIOC4B, TIOC4C, and TIOC4D). High-level outputs

can be achieved by setting the MTU internal registers.

SH7101 Datasheet(PDF) 303 Page - Renesas Technology Corp