82801AB datasheet(35/414 Pages) INTEL

35 / 414 page

82801AA and 82801AB Datasheet

2-7

Signal Description

2.8

Power Management Interface

Table 2-8. Power Management Interface Signals

Name

Type

Description

THRM#

Thermal Alarm: Active low signal generated by external hardware to start the

Hardware clock throttling mode. Can also generate an SMI# or an SCI.

SLP_S3#/

GPIO[24]

S3 Sleep Control: Power plane control. The signal is used to shut power off to all

non-critical systems when in S3 (Suspend To RAM) state. It can be used as General

Purpose Output if STR is not supported.

SLP_S5#

S5 Sleep Control: Power plane control. The signal is used to shut power off to all

non-critical systems when in the S4 (Suspend To Disk) or S5 (Soft Off) states.

PWROK

Power OK: When asserted, PWROK is an indication to the ICH that core power and

PCICLK have been stable for at least 1 ms. PWROK can be driven asynchronously.

When PWROK is negated, the ICH asserts PCIRST#.

PWRBTN#

Power Button: The Power Button will cause SMI# or SCI to indicate a system

request to go to a sleep state. If the system is already in a sleep state, this signal will

cause a wake event. If PWRBTN# is pressed for more than 4 seconds, this will cause

an unconditional transition (power button override) to the S5 state with only the

PWRBTN# available as a wake event. Override will occur, even if the system is in the

S1-S4 states.

RI#

Ring Indicate: From the modem interface. Can be enabled as a wake event and this

is preserved across power failures.

RSMRST#

Resume Well Reset: Used for resetting the resume power plane logic.

SUS_STAT#/

GPIO[25]

Suspend Status: This signal is asserted by the ICH to indicate that the system will

be entering a low power state soon. This can be monitored by devices with memory

that need to switch from normal refresh to suspend refresh mode. It can also be used

by other peripherals as an indication that they should isolate their outputs that may

be going to powered-off planes. This signal is called LPCPD# on the LPC Interface.

NOTE: Can be used as General Purpose Output if external logic does not require

this signal.

SUSCLK/

GPIO[26]

(82801AA

only)

Suspend Clock (82801AA only): Output of the RTC generator circuit to use by

other chips for refresh clock.

NOTES:

1. Can be used as General Purpose Output if external logic does not require this

signal.

2. GPIO[26] is a non-muliplexed signal on the ICH0 (82801AB).

82801AB Datasheet(PDF) 35 Page - Intel Corporation

82801AB Datasheet(HTML) 35 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL