HD6433644R datasheet(335/549 Pages) RENESAS

335 / 549 page

Section 10 Serial Communication Interface

Rev. 6.00 Sep 12, 2006 page 315 of 526

REJ09B0326-0600

Clock: Either an internal clock generated by the baud rate generator or an external clock input at

the SCK3 pin can be selected as the SCI3 transmit/receive clock. The selection is made by means

of bit COM in SMR and bits CKE1 and CKE0 in SCR3. See table 10.12 for details on clock

source selection.

When an external clock is input at the SCK3 pin, a clock with a frequency of 16 times the bit rate

used should be input.

When SCI3 operates on an internal clock, the clock can be output at the SCK3 pin. In this case the

frequency of the output clock is the same as the bit rate, and the phase is such that the clock rises

at the center of each bit of transmit/receive data, as shown in figure 10.9.

1 character (1 frame)

D4D5D6

0/1

Clock

Serial

data

Figure 10.9 Phase Relationship between Output Clock and Transfer Data

(Asynchronous Mode) (8-Bit Data, Parity, 2 Stop Bits)

Data Transfer Operations

SCI3 Initialization: Before data is transferred on SCI3, bits TE and RE in SCR3 must first be

cleared to 0, and then SCI3 must be initialized as follows.

Note: If the operation mode or data transfer format is changed, bits TE and RE must first be

cleared to 0.

When bit TE is cleared to 0, bit TDRE is set to 1.

Note that the RDRF, PER, FER, and OER flags and the contents of RDR are retained

when RE is cleared to 0.

When an external clock is used in asynchronous mode, the clock should not be stopped

during operation, including initialization. When an external clock is used in synchronous

mode, the clock should not be supplied during operation, including initialization.

HD6433644R Datasheet(PDF) 335 Page - Renesas Technology Corp