AM8530 datasheet(140/194 Pages) AMD

140 / 194 page

AMD

6–30

Bit 7: Break/Abort IE

If this bit is set to ‘1’, a change in the Break/Abort status of the receiver causes an Exter-

nal/Status interrupt. This bit is set by a channel or hardware reset.

Bit 6: Tx Underrun/EOM

If this bit is set to ‘1’, a change of state by the Tx Underrun/EOM latch in the transmitter

causes an External/Status interrupt. This bit is set to ‘1’ by a channel or hardware reset.

Bit 5: CTS IE

If this bit is set ‘1’, a change of state on the

CTS pin causes an External/Status interrupt.

This bit is set by a channel or hardware reset.

Bit 4: SYNC/Hunt IE

If this bit is set to ‘1’, a change of state on the

SYNC pin causes an External/Status inter-

rupt in Asynchronous mode, and a change of state in the Hunt bit in the receiver causes

an External/Status interrupt in synchronous modes. This bit is set by a channel or hard-

ware reset.

Bit 3: DCD IE

If this bit is set to ‘1’, a change of state on the

DCD pin causes an External/Status inter-

rupt. This bit is set by a channel or hardware reset.

Bit 2 10x19–Bit Frame Status FIFO Enable

If this bit is set to ‘1’, the 10X19-bit FIFO array and 14-bit counter are available for use but

only if the SCC is programmed in SDLC mode.

Bit 1: Zero Count IE

If this bit is set to ‘1’, an External/Status interrupt is generated whenever the counter in

the baud rate generator reaches ‘0’. This bit is set to ‘0’ by a channel or hardware reset.

Bit 0: SDLC/HDLC Enhancement Enable

If this bit is set to ‘1’, WR7

′ can be accessed as WR7′ to allow the use of special SDLC/

HDLC options. Refer to WR7

′ for details.

6.3

READ REGISTERS

The SCC contains nine read registers in each channel. The status of these registers is

continually changing and depends on the mode of communication, received and transmit-

ted data, and the manner in which this data is transferred to and from the CPU. The fol-

lowing description details the bit assignments for each register.

6.3.1

Read Register 0 (Transmit/Receive Buffer Status

and External Status)

Read Register 0 contains the status of the receive and transmit buffers. RR0 also con-

tains the status bits for the six sources of External/Status interrupts. The bit configuration

is illustrated in Figure 6–18.

AM8530 Datasheet(PDF) 140 Page - Advanced Micro Devices

AM8530 Datasheet(HTML) 140 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL