| Electronic Components Datasheet Search |
|
ADSP-SC583 Datasheet(PDF) 8 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
ADSP-SC583 Datasheet(HTML) 8 Page - Analog Devices |
|
8 / 173 page ![]() Rev. B | Page 8 of 173 | December 2018 ADSP-SC582/SC583/SC584/SC587/SC589/ADSP-21583/21584/21587 The memory map in Table 4 gives the L1 memory address space and shows multiple L1 memory blocks offering a configurable mix of SRAM and cache. L1 Master and Slave Ports Each SHARC+ core has two master and two slave ports to and from the system fabric. One master port fetches instructions. The second master port drives data to the system world. Both slave ports allow conflict free core/direct memory access (DMA) streams to the individual memory blocks. For slave port addresses, refer to the L1 memory address map in Table 4. L1 On-Chip Memory Bandwidth The internal memory architecture allows programs to have four accesses at the same time to any of the four blocks, assuming no block conflicts. The total bandwidth is realized using both the DMD and PMD buses. Instruction and Data Cache The ADSP-SC58x/ADSP-2158x processors also include a traditional instruction cache (I-cache) and two data caches (D-cache) (PM and DM caches). These caches support one instruction access and two data accesses over the DM and PM buses, per CCLK cycle. The cache controllers automatically manage the configured L1 memory. The system can configure part of the L1 memory for automatic management by the cache controllers. The sizes of these caches are independently configu- rable from 0 kB to a maximum of 128 kB each. The memory not managed by the cache controllers is directly addressable by the processors. The controllers ensure the data coherence between the two data caches. The caches provide user-controllable fea- tures such as full and partial locking, range-bound invalidation, and flushing. System Event Controller (SEC) Input The output of the system event controller (SEC) controller is forwarded to the core event controller (CEC) to respond directly to all unmasked system-based interrupts. The SEC also supports nesting including various SEC interrupt channel arbi- tration options. For all SEC channels, the processor automatically stacks the arithmetic status (ASTATx and ASTATy) registers and mode (MODE1) register in parallel with the interrupt servicing. Core Memory-Mapped Registers (CMMR) The core memory-mapped registers control the L1 instruction and data cache, BTB, L2 cache, parity error, system control, debug, and monitor functions. SHARC+ CORE ARCHITECTURE The ADSP-SC58x/ADSP-2158x processors are code compatible at the assembly level with the ADSP-2148x, ADSP-2147x, ADSP-2146x, ADSP-2137x, ADSP-2136x, ADSP-2126x, ADSP-2116x, and with the first-generation ADSP-2106x SHARC processors. The ADSP-SC58x/ADSP-2158x processors share architectural features with the ADSP-2126x, ADSP-2136x, ADSP-2137x, ADSP-214xx, and ADSP-2116x SIMD SHARC processors, shown in Figure 4 and detailed in the following sections. SIMD Computational Engine The SHARC+ core contains two computational processing ele- ments that operate as a single-instruction, multiple data (SIMD) engine. Figure 5. ADSP-SC58x/ADSP-2158x Memory Map 0x FFFF FFFF 0x C000 0000 0x 8000 0000 0x 6000 0000 0x 5000 0000 0x 4C00 0000 0x 4800 0000 0x 4400 0000 0x 4000 0000 0x 3000 0000 0x 28F9 FFFF 0x 28A4 0000 0x 2879 FFFF 0x 2824 0000 0x 202B FFFF 0x 201B FFFF 0x 2028 0000 0x 2020 7FFF 0x 2020 0000 0x 2018 0000 0x 2010 7FFF 0x 2010 0000 0x 200B FFFF 0x 2008 0000 0x 2000 7FFF DMC1 (1GB) DMC0 (1GB) SPI2 FLASH (512MB) PCIe (256MB) SMC BANK 3 (64MB) SMC BANK 2 (64MB) SMC BANK 1 (64MB) SMC BANK 0 (64MB) SYSTEM MMR RESERVED SHARC2 L1 MULTI-MEMORY SPACE RESERVED SHARC1 L1 MULTI-MEMORY SPACE RESERVED L2 ROM 2 (2Mb) RESERVED L2 BOOT ROM 2 (0.25Mb) (SHARC Cores) RESERVED L2 ROM 1 (2Mb) RESERVED RESERVED L2 SRAM (2Mb) RESERVED L2 BOOT ROM 0 (0.25Mb) (ARM CORE 0) L2 BOOT ROM 1 (0.25Mb) (SHARC Cores) 0x 2000 0000 0x 0039 FFFF 0x 0038 0000 0x 0031 FFFF 0x 0030 0000 0x 002E FFFF 0x 002C 0000 0x 0026 FFFF 0x 0024 0000 0x 0000 0000 RESERVED L1 BLOCK 3 SRAM (1Mb) RESERVED RESERVED RESERVED L1 BLOCK 2 SRAM (1Mb) L1 BLOCK 1 SRAM (1.5Mb) L1 BLOCK 0 SRAM (1.5Mb) RESERVED/CORE MMRs/ OTHER MEMORY ALIASES RESERVED ARM L2 CONFIG REGS (4KB) RESERVED ARM BOOT (32KB) 0x 2000 0000 0x 1000 1000 0x 1000 0000 0x 0000 7FFF 0x 0000 0000 UNIFIED BYTE ADDRESS SPACE |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |