ST7637 datasheet(72/210 Pages) SITRONIX

72 / 210 page

ST7637

Ver 1.6

72/210

2009/03

9.1.2.

SWRESET: Software Reset (01h)

Command

/RD

/WR

Hex

SWRESET

(01h)

Parameter

No Parameter

Description

When the Software Reset command is written, it causes a software reset. It resets the

commands and parameters to their S/W Reset default values and all segment &

common outputs are set to Vm (display off: blank display). (See default tables in each

command description)

Note: The Frame Memory contents are not affected by this command.

Restriction

It will be necessary to wait 5msec before sending new command following software

reset. The display module loads all display suppliers’ factory default values to the

registers during 5msec. If Software Reset is applied during Sleep Out mode, it will be

necessary to wait 120msec before sending Sleep Out command.

Software Reset command cannot be sent during Sleep Out sequence.

Availability

Status

Availability

Normal Mode On, Idle Mode Off, Sleep Out

Yes

Normal Mode On, Idle Mode On, Sleep Out

Yes

Partial Mode On, Idle Mode Off, Sleep Out

Yes

Partial Mode On, Idle Mode On, Sleep Out

Yes

Sleep In

Yes

Default

Status

Default Value

Power On Sequence

N/A

S/W Reset

N/A

H/W Reset

N/A

Flow Chart

ST7637 Datasheet(PDF) 72 Page - Sitronix Technology Co., Ltd.

ST7637 Datasheet(HTML) 72 Page - Sitronix Technology Co., Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL