82G33 datasheet(89/437 Pages) INTEL

89 / 437 page

DRAM Controller Registers (D0:F0)

Datasheet

5.1.4

PCISTS—PCI Status

B/D/F/Type:

0/0/0/PCI

Address Offset:

6–7h

Default Value:

0090h

Access:

RWC, RO

Size:

16 bits

This status register reports the occurrence of error events on Device 0's PCI interface.

Since the (G)MCH Device 0 does not physically reside on PCI_A many of the bits are

not implemented.

Bit

Access &

Default

Description

RWC

Detected Parity Error (DPE):

1= Device received a Poisoned TLP.

RWC

Signaled System Error (SSE): Software clears this bit by writing a 1

to it.

1= The (G)MCH Device 0 generated a SERR message over DMI for any

enabled Device 0 error condition. Device 0 error conditions are

enabled in the PCICMD, ERRCMD, and DMIUEMSK registers. Device

0 error flags are read/reset from the PCISTS, ERRSTS, or DMIUEST

registers.

RWC

Received Master Abort Status (RMAS): Software clears this bit by

writing a 1 to it.

1 = (G)MCH generated a DMI request that receives an Unsupported

Request completion packet.

RWC

Received Target Abort Status (RTAS): Software clears this bit by

writing a 1 to it.

1 = (G)MCH generated a DMI request that receives a Completer Abort

completion packet.

Signaled Target Abort Status (STAS): The (G)MCH will not

generate a Target Abort DMI completion packet or Special Cycle. This

bit is not implemented in the (G)MCH and is hardwired to a 0.

10:9

00b

DEVSEL Timing (DEVT): These bits are hardwired to "00". Writes to

these bit positions have no affect. Device 0 does not physically connect

to PCI_A. These bits are set to "00" (fast decode) so that optimum

DEVSEL timing for PCI_A is not limited by the (G)MCH.

RWC

Master Data Parity Error Detected (DPD):

1 = This bit is set when DMI received a Poisoned completion from the

ICH.

NOTE: This bit can only be set when the Parity Error Enable bit in the

PCI Command register is set.

Fast Back-to-Back (FB2B): This bit is hardwired to 1. Device 0 does

not physically connect to PCI_A. This bit is set to 1 (indicating fast

back-to-back capability) so that the optimum setting for PCI_A is not

limited by the (G)MCH.

82G33 Datasheet(PDF) 89 Page - Intel Corporation

82G33 Datasheet(HTML) 89 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL