HC210 datasheet(126/228 Pages) ALTERA

126 / 228 page

5–34

Altera Corporation

September 2008

HardCopy Series Handbook, Volume 1

Figure 5–16. Close-Up View of Floorplan

The HardCopy Design Center performs final placement and timing

closure on your HardCopy II design based on the timing constraints

provided in the Stratix II design.

For more information about the HardCopy Design Center’s process,

refer to the Back-End Design Flow for HardCopy Series Devices chapter in

volume 1 of the HardCopy Series Device Handbook.

Conclusion

You can use the Quartus II software to design HardCopy II devices and to

develop prototypes using Stratix II FPGAs. This is done using the

standard FPGA development process with the addition of the

HardCopy II Device Resource Guide, HardCopy II Companion Devices

assignment HardCopy II Utilities, and the HardCopy II Advisor.

The addition of the HardCopy II Advisor to the Quartus II software

provides an instrumental development guide for you to complete your

HardCopy II and Stratix II device designs. The HardCopy II Utilities

included in the Quartus II software provide you with the tools necessary

to complete your Stratix II FPGA prototype and HardCopy II structured

ASIC design. The addition of the HardCopy II companion revisions

feature to the process allows for rapid development and verification that

your HardCopy II design is functionally equivalent to your Stratix II

FPGA prototype.

HC210 Datasheet(PDF) 126 Page - Altera Corporation