| Electronic Components Datasheet Search |
|
8101 Datasheet(PDF) 77 Page - LSI Computer Systems |
|
|
|||||||||||||||||||||||||||||
8101 Datasheet(HTML) 77 Page - LSI Computer Systems |
|
77 / 172 page ![]() Loopback 2-59 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved. 2.20 Loopback To enable the diagnostic loopback mode, set the LPBK bit in “Register 10–Configuration 4‚" Section 4.3.11. When the loopback mode is enabled, the transmit data input to the transmit system interface and output from the 8B10B encoder is internally looped back into the receive 8B10B decoder and is available to be read from the receive system interface. 2.21 Test Modes The TEST pin is reserved for factory test, and must be tied LOW for normal operation. Asserting the TAP pin HIGH, sets all inputs and outputs in the high-impedance state. This pin is intended for controller and board diagnostic testing. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |