| Electronic Components Datasheet Search |
|
HC210 Datasheet(PDF) 186 Page - Altera Corporation |
|
|
|||||||||||||||||||||||||||||
HC210 Datasheet(HTML) 186 Page - Altera Corporation |
|
186 / 228 page ![]() 7–22 Altera Corporation September 2008 HardCopy Series Handbook, Volume 1 If you do wish to translate existing, unsupported timing constraints to recommended constraints, use Table 7–1 as a rough guide. It shows how values used in TCO, Th, TSU, and Min TCO assignments normally convert to values used in recommended HardCopy II assignments. In the table, unsupported constraints are listed in the left hand column. Recommended constraints are listed along the top row. To use the table, cross-reference the unsupported constraints you wish to translate against a recommended constraint. The cross reference cell contains the conversion of the original, unsupported constraint value that should be used with the new, recommended constraint. It is very important to note that these translations are not valid in every design scenario. Conclusion This chapter described timing considerations and Quartus II timing constraint recommendations for HardCopy II projects. By understanding these considerations and following the recommendations in your design, you ensure a smooth transition through the Quartus II software and subsequent transfer to the Altera HardCopy Design Center for the back-end design of your structured ASIC. Following the recommendations in this chapter will help ensure success in your HardCopy II project. Table 7–1. TSU, TH, TCO, and Minimum TCO Timing Constraint Conversion Notes (1), (2), (3), (4), (5) setup_relationship set_input_delay hold_relationship set_output_delay TSU Req TSU -max <TCK-TSU> Th Req -min Th -Th TCO Req TCO -max <TCK-TCO> Min TCO Req Min TCO -min <- Min TCO> Note to Table 7–1: (1) TSU = value used in the TSU requirement assignment. (2) TCO = value used in the TCO requirement assignment. (3) Th = value used in the Th requirement assignment. (4) Min TCO = value used in Min TCO requirement assignment. (5) TCK = period of the clock for registers associated with the TSU and TCO requirements. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |